Table of Contents
Advertisement
Remote control operation
In addition to the remote control of the receiver unit, the provided remote control unit can control
a KENWOOD
cassette tape deck, CD player, turntable, graphic equalizer, etc., connected via the KENWOOD system control cords.
@ Loading batteries
Remove the cover.
e While gently pressing the cover located on the rear of
the remote control unit, slide it in the direction of the
arrow,
Insert batteries.
@ Make sure that the batteries are inserted as indicated
with the polarity marking on the bottom.
Notes:
The batteries provided are to be used for checking the
f
remote control operations. Their service life may be short.
3
Close the cover.
14 KR-V8040 (En)
Operating
range of the remote
control unit
The normal operating range may change depending
|
on temperature, humidity, and other environmental
conditions, but it is roughly specified as shown in the
figure.
Remote conirol
|
light receptor
Approx.
6 m
Model: RC-8040
Infrared system
Note:
1. If two or more
remote
contro! operation
keys are to be
pressed successively, press each key securely and leave an
interval of more than 1 second between presses.
Pressing a key immediately after pressing another key may
cause malfunction.
2, Malfunction may occur in case direct sunlight or the light of
a high-frequency lighting fluorescent lamp enters the remote
control light receptor. In such a case, change the installation
position of the unit so that the malfunction does not occur.
Advertisement
Table of Contents
