Table of Contents
Advertisement
Se
ee
Se
a
ee
Step 3: Hookups
Log
Caution
Connections between the
VCR's VHF/UHF connector
and the antenna terminals of
the TV receiver should be
made only as shown in the
following instructions. Failure
to do so may result in
operation that violates the
regulations of the Federal
Communications Commission
regarding the use and
operation of RF devices. Never
connect the output of the VCR
to an antenna or make
simultaneous (parallel)
antenna and VCR connections
at the antenna terminals of
your receiver.
Note to CATV system
installer
This reminder is provided to
call the CATV system
installer's attention to Article
820-40 of the NEC that
provides guidelines for proper
grounding and, in particular,
specifies that the cable ground
shall be connected to the
grounding system of the
building, as close to the point
of cable entry as practical.
Selecting the best hookup option
Before you can use your VCR for the first time, you need to connect it to
your TV and set it up to receive programs for viewing and recording.
This section explains how to hook up and set up your VCR so that you
can start enjoying"it right away. There are, however, many types of TVs
available and many ways in which your TV can be hooked up. For these
reasons, this manual describes several ways your VCR can be
connected.
To hook up your VCR so that it works best for you, first scan through
the table below. Then use the accompanying diagrams and procedures
on the following pages to set up your VCR.
If you have
.
Use
Refer to
TV that has audio/video inputs
§ Audio/video (A/V) hookup,
Page 8
then follow one of the hookups
below.
No cable box or cable box with
Hookup 1
Page 10
only a few scrambled channels
Antenna only, no cable TV
Hookup 2
Page 12
Cable box with many scrambled
Hookup 3
Page 14
channels
Cable box with only a few
Hookup 4
Page 16
scrambled channels, using an
A/B
switch
After you've completed the connections, follow the instructions for
setup including VCR Plus+ setup. During setup, if youneed more
details of the procedure described, page numbers are provided where
you can find complete, step-by-step instructions.
After you've completed the setup, you're ready to use your VCR.
Procedures differ depending on the hookup you used. For an overview,
refer to "Quick reference to using the VCR" on the back cover.
Before you get started
e Turn off the power to all equipment.
¢ Do not connect the AC power cords until all of the connections are
completed.
e Be sure you make connections firmly. Loose connections may cause
picture distortion. -..
° If your TV doesn't match any of the examples provided, see your
nearest Sony dealer or qualified technician.
Getting Started
7
peers
BunzeD
—
Advertisement
Table of Contents
