Table of Contents
Advertisement
1
insert a source tape with its safety
tab slid out to show the red
portion into the other (playback)
VCR. Search for the point to start
playback and set it to playback
pause.
2
siinmserta tape for recording into this
(recording) VCR. Search for the
point to start recording and press
il PAUSE.
3
Press @ REC on this VCR and set it
to recording pause mode.
CH+/-
4
press the 11 PAUSE button on both
VCRs to start editing
For best results, press the pause button on the
playback VCR just before pressing Ill PAUSE
on this VCR.
IE PAUSE
@ REC
To stop editing
Press the Ml STOP buttons on both VCRs.
m@ STOP
Note
e Make sure that the safety tab
is in the correct position. If
the playback VCR is a VHS
model, make sure that the
safety tab on the source tape
has been removed.
Tips
e To make your editing more
precise, release the VCRs
from pause by pressing HI
PAUSE buttons on the
VCRs, not on the remote
commander.
To cut at unwanted events
while editing, press Ii
PAUSE on this VCR when
an unwanted scene begins,
when it ends, press U8
PAUSE again to resume
recording (assemble editing).
38
Editing
Advertisement
Table of Contents
