Installation; Interface Ic Kit - Kenwood TS-440S Instruction Manual

IF unit
6-3. INTERFACE IC KIT IC-10 INSTALLATION
Installing the optional iC-10 kit will allow control of the
radio from a personal computer. The following opera-
tions are possible:
© Programming and recail of VFO A and VFO B fre-
quency
MR (Memory Recall) and M.IN {Memory Input}
Microphone UP/DOWN frequency control disable
Control of the F.LOCK switch
Memory channel! selection
MODE selection
Control of RIT/XIT
Selection of RIT/XIT frequency
Scan operation
Review of transceiver status
6-3-1. Installation
+. Remove the top and bottom covers from the radio.
2. Remove the countersink screws (2 on each side)
that secure the front panel to the chassis and gently
pull the front panel forwards.
3. Remove the 5 smail round head screws that secure
the shield plate (2 on the top and 3 on the bottom)
to the front panel, and remove the shield plate.
4. Install the IC's into the vacant sockets on the Con-
trol unit. Orientation of this component is critical
for proper operation of the radio, and interface.
Caution:
Install the IC's so that the notch in the end is on
the same end as the notch in the IC socket.
Front pane!
(C54: »PD8251AC (NEC) or equivalent
[Ces : TC4040BP (Toshiba) or equivalent
5. Reverse steps 1.—3. to reassembie the radio.
Caution:
Do not pinch and stretch any wires.
6-3-2. Operation
Refer to the instruction manual provided with the IC-10
Interface IC Kit.
29