Parrot ANAFI Ai User Manual page 75

In both scenarios, the Flight Plan project screen opens. Edit the PROJECT NAME and tap Done to
continue to the flight plan.
1. Currently selected waypoint
2. Flight path segment
3. Waypoints linked to POI 1
4. Camera direction
5. Altitude
6. Waypoint number
Note: In the screenshot above, POI 1 is obstructed by the linked waypoints.
Choose the location of your initial waypoint, ideally, very close to your intended take-off point. Tap
the screen to create the waypoint. The waypoint appears as a green circle. The white figure in the
center represents the drone altitude, and the green arrow represents the camera direction.
Change the direction of the ANAFI Ai's camera by pressing and holding on the green arrow. Rotate the
arrow to the desired camera direction.
Tap the map to create more waypoints. By default, the new WP is set at the same altitude and camera
angle as the previous WP. The camera points in the direction of the flight which brought the drone to
the new WP.
Tap the flight path segment between 2 waypoints to activate the Segment interface. You can modify
ANAFI Ai's speed for any flight segment (from 0.5 m/s to 12 m/s by 0.5 m/s increments – default value:
5 m/s).
Tap the + plus on the middle of the segment to create a new WP there. By default, the altitude of the
new WP considers flight level change between the previous WP and the next WP.
To change the height of an individual waypoint, tap the desired waypoint. Drag the slider on the right
of the screen to modify the altitude. In the example above, ANAFI Ai climbs from 37 meters at the
currently selected waypoint to 50 meters for the following waypoint.
To change ANAFI Ai's camera angle at a given waypoint, tap the desired waypoint. Drag the slider on
the right of the screen to modify the camera angle.
© 2023 Parrot Drones SAS. All Rights Reserved.
7. Point of Interest (POI) 2
8. Altitude slider
9. Camera angle slider
10. Delete
11. Undo
A N A F I A i
75