Table of Contents
Advertisement
T
ROUBLESHOOTING
W
P
J
HEN
APER
AMS
When removing jammed paper, make sure that no pieces of torn
paper are left in the machine. If a sheet of paper is wrapped around
the heat roller, or when clearing a jammed paper that is difficult or
impossible to see, do not try to remove it by yourself. Doing so can
cause injuries or burns. Switch off the machine immediately, and
contact your dealer or service.
Following the message on the control panel, open the cover and remove the jammed paper.
If paper is torn, check for any remaining torn pieces of paper.
I
C
A
NSIDE
OVER
When the optional offset catch tray is installed, fold the tray first before opening cover A.
Open Cover A when a message to remove the drum/toner cartridge is displayed.
1.
Open cover A (1), and holding the drum/toner
cartridge by the grip, remove it from the printer (1).
2.
Turn the roll as shown and remove any jammed
paper inside (2).
3.
Return the drum/toner cartridge and cover A to
their original positions.
NOTE
>
When the optional offset catch tray is installed, close cover A first before
returning the tray to its original position.
>
If you continue to print with the offset catch tray folded, this may cause a
paper jam. Always use the printer with the tray open.
I
P
T
NSIDE
APER
RAY
Pulling out paper trays
1.
Pull out all paper trays and remove any wrinkled paper.
2.
Examine the inside of the printer and remove any
jammed paper.
After removing paper,
1.
Push the paper trays completely back into the printer.
2.
Open and close cover A. Doing this will clear the error
message.
CAUTION!
Troubleshooting > 25
Advertisement
Table of Contents
