Table of Contents
Advertisement
Installing Device
2.3.3 Mounting the Device to a Panel
To mount the device to a DIN rail, do the following:
1.
2.
2.3.3
Mounting the Device to a Panel
For panel installations, the RUGGEDCOM RS1600 can be equipped with panel/DIN rail
adapters pre-installed on each side of the chassis. The adapters allow the device to
be attached to a panel using screws.
To mount the device to a panel, do the following:
1.
10
Align the adapters with the DIN rails and slide the device into place.
3
Panel/DIN Rail Adaptor
1
DIN Rail
2
Screw
3
Figure 2.2
DIN Rail Mounting
Install one of the supplied screws on either side of the device to secure the
adapters to the DIN rails.
Place the device against the panel and align the adapters with the mounting
holes.
RUGGEDCOM RS1600
Installation Manual, 11/2022, C79000-G8976-1013-04
1
2
3
Advertisement
Table of Contents
