Maintenance Table; Troubleshooting - Stiga CS 100 Li 20 A Operator's Manual

13. MAINTENANCE TABLE

Intervention
MACHINE
Check all fasteners
Safety checks/check controls
Check the chain catcher
General cleaning and inspection
Cleaning the chain
Check the machine and bar lubrication holes
Check the chain drive sprocket
Chain maintenance
Bar maintenance
Topping up the chain oil level
* Interventions which must be carried out by your dealer or an authorised service centre

14. TROUBLESHOOTING

PROBLEM
1. Activatingthe the throttle
trigger lever and the
throttle lock button, the
machine does not start
2. The motor shuts down
whilst working
First time
-
-
-
-
-
-
-
-
-
-
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
Low battery
Machine damaged
Battery is not inserted correctly
Low battery
Machine damaged
A motor protection trips
EN - 16
Frequency
And then after
every
Before each use
Before each use
Before each use
After each use
After each use
Before each use
Once a month
-
-
Before each use
SOLUTION
Make sure that the battery is
inserted correctly (par. 7.2.3)
Check the battery
status and recharge if
necessary (par. 7.2.2).
Do not use the machine
Remove the battery and
Contact a Service Centre
Make sure that the battery is
inserted correctly (par. 7.2.3)
Check the battery
status and recharge if
necessary (par. 7.2.2).
Do not use the machine
Remove the battery and
Contact a Service Centre.
wait 15min for the machine to
cool down and then restart it
Paragraph
7.7
6.2
7.5
7.4
7.4.2
7.6
8.1 *
8.2 *
8.3
7.3