Table of Contents
Advertisement
Figure 30
Transport-Lock Positions
1. Transport lock
2. L
position—mower
OCK
deck locks into transport
position
g032377
3. U
position—does
NLOCK
not lock the mower deck
into transport position
Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1
to 5-1/2 inches) in 6 mm (1/4 inch) increments by
relocating the clevis pin into different hole locations.
1.
Move the transport lock to the lock position.
2.
Push on the deck-lift pedal with your foot, and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inches) cutting height
position) as shown in
3.
To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket
31).
4.
Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin
(Figure
5.
Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
1. Deck-lift pedal
2. Cut-of-height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
26
Figure
31.
(Figure
31).
Figure 31
3. Transport lock
EUTRAL
g190360
-
LOCK
Advertisement
Table of Contents
