Table of Contents
Advertisement
7.
Install the replacement hydraulic filter.
8.
Install the pump-drive belt and the mower belt.
9.
Remove the jack stands and lower the machine
(Figure
90).
10.
Add oil to the hydraulic reservoir and check for
any leaks.
11.
Clean up any spilled oil.
12.
Start the engine and let it run for about 2 minutes
to purge air from the system.
13.
Shut off the engine and check for leaks.
14.
Check the oil level while the oil is cold.
15.
If required, add oil to the hydraulic reservoir.
Note:
Do not overfill.
Mower Deck
Maintenance
Leveling the Mower Deck
Setting Up the Machine
Note:
Ensure that the mower deck is level before
matching the height-of-cut (HOC).
1.
Position mower on a flat surface.
2.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
3.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4.
Check tire pressure of the tires. If needed,
adjust to 90 kPa (13 psi).
5.
Position the mower to the 76 mm (3 inches)
height-of-cut position.
Leveling the Deck
1.
Position the mower on a flat surface.
2.
Shut off the engine, wait for all moving parts to
stop, and remove key. Engage parking brake.
3.
Check the tire pressure in the drive tires.
Note:
Proper inflation pressure for the tires is
90 kPa (13 psi).
4.
Position the transport lock in the latching
position.
5.
Push the deck-lift pedal all the way forward and
the deck latches at the 14 cm (5 1/2 inches)
T
position
RANSPORT
60
-
EUTRAL
LOCK
(Figure
92).
Advertisement
Table of Contents
