Table of Contents
Advertisement
WARNING
Hydraulic fluid escaping under pressure
can penetrate skin and cause injury.
• If hydraulic fluid is injected into the
skin it must be surgically removed
within a few hours by a doctor familiar
with this type of injury. Gangrene may
result if this is not done.
• Keep your body and hands away from
pinhole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find
hydraulic leaks.
• Safely relieve all pressure in the
hydraulic system before performing
any work on the hydraulic system.
• Make sure that all hydraulic-oil hoses
and lines are in good condition, and
all hydraulic connections and fittings
are tight before applying pressure to
the hydraulic system.
Replacing the Hydraulic Fluid and
Filters
Service Interval: After the first 250 hours—Change
the hydraulic filters and hydraulic
fluid when using any type of fluid.
Every 250 hours—Change the hydraulic filters
and hydraulic fluid when using Mobil
(more often in dirty or dusty conditions).
Every 500 hours—Change the hydraulic
filters and hydraulic fluid when using Toro
HYPR-OIL
™
500 hydraulic fluid (more often in
dirty or dusty conditions).
To replace the hydraulic fluid, the filters need to
be removed. Replace both at the same time; refer
to
Servicing the Engine Oil (page 39)
specifications.
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Raise the machine and support it with jack
stands
(Figure
90).
1. Jack stands
4.
5.
®
1 fluid
®
for the oil
-
EUTRAL
LOCK
1. Filter locations
6.
59
Figure 90
Remove both the mower belt and the pump-drive
belt; refer to
Replacing the Mower Belt (page
53)
and
Replacing the Hydraulic Pump-Drive
Belt (page
55).
Note:
This prevents oil from getting on the
belts.
Place a drain pan under the filter, remove the
old filter, and wipe the surface clean
Figure 91
Bottom view of the machine
Apply a thin coat of hydraulic fluid to the rubber
gasket on the replacement filter
g008970
(Figure
91).
g008968
2. Hydraulic filter
(Figure
91).
Advertisement
Table of Contents
