Toro 75934 Operator's Manual page 11

Note:
This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the maximum
recommended slope indicated on the decal. Review the instructions for operating the machine on slopes in the Operator's Manual as
well as the conditions in which you would operate the machine to determine whether you can operate the machine in those conditions
on that day and at that site. Changes in the terrain can result in a change in slope operation for the machine. If possible, keep the
cutting units lowered to the ground while operating the machine on slopes. Raising the cutting units while operating on slopes can
cause the machine to become unstable.
1. Warning—read the Operator's Manual; do not operate this
machine unless you are trained; wear hearing protection.
2. Cutting, dismembering, and entanglement hazard—keep
hands away from moving parts; keep all guards and shields in
place.
3. Thrown object hazard—keep bystanders away.
132-0871
4. Ramp hazard—when loading onto a trailer, do not use dual
ramps; only use a singular ramp wide enough for the machine
and that has an incline less than 15°; back up the ramp (in
reverse) and drive forward off the ramp.
5. Bodily harm hazard—do not carry passengers; look behind
you when mowing in reverse.
6. Tipping hazard on slopes—do not use on slopes near open
water; do not use on slopes greater than 15°.
132-5067
11
decal132-0871
decal132-5067