Specifications; Before Assembly - Schwinn 590e Owner's Manual

Power Requirements: 120V
Operational Voltage:
Operating Current:
Maximum User Weight:
Total Surface Area (footprint) of equipment: 12,723 cm
Maximum Pedal Height - with full incline:
Machine Weight:
This product complies with the European Radio Equipment Directive
2014/53/EU
DO NOT dispose of this product as refuse. This product is to be
recycled. For proper disposal of this product, please follow the
prescribed methods at an approved waste center.

Before Assembly

Select the area where you are going to set up and operate your machine. For safe operation, the location must be on a
hard, level surface. Allow a minimum workout area of 82.1 in x 57.9 in (208.5 cm x 147.1 cm). Keep the workout area clear
0.6 m (24 in) along the side used to access the machine and to the rear of the machine. Be sure that the workout space
you are utilizing has adequate height clearance, taking into consideration the height of the user and the maximum incline
of the elliptical machine. Estimated time to assemble the machine is 60 - 90 minutes.
NOTICE: Inspect the machine for damaged parts due to delivery. If
damage is found, contact Customer Service (if inside US/
Canada) or your local distributor (if outside US/Canada) for
assistance.
Basic Assembly
Follow these basic points when you assemble your machine:
• Read and understand the "Important Safety Instructions" before
assembly.
• Collect all the pieces necessary for each assembly step.
• Using the recommended wrenches, turn the bolts and nuts to the right (clockwise) to tighten, and the left
(counterclockwise) to loosen, unless instructed otherwise.
• When attaching 2 pieces, lightly lift and look through the bolt holes to help insert the bolt through the holes.
• The assembly requires 2 people.
• Do not use any power tools for assembly.
Machine Mat
The Schwinn™ Machine Mat is an optional accessory that helps keep your workout area clear and adds a layer of
protection to your floor. The rubber machine mat provides a non-slip, rubber surface which limits static discharge and
reduces the possibility of display errors. If possible, put your Schwinn™ Machine Mat in your selected workout area before
you begin assembly.
To order the optional machine mat, contact Customer Service (if purchased in US/Canada) or your local distributor (if
purchased outside US/Canada).
220V
110-127V AC, 60Hz 220V - 240V AC, 50Hz
2A 2A
150 kg (330 lb)
28.3 in ( 72 cm)
approx. 84.8 kg (187 lb)
SPECIFICATIONS / BEFORE ASSEMBLY
2
86.2 cm
( 33.9 in )
0.6 m
( 24 in )
1.5 m
(57.9 in)
172.6 cm
( 68 in )
147.6 cm ( 58.1 in )
2.1 m (82.1 in)
0.6 m
( 24 in )
9