Advertisement
roubieshooting
ften what seems to be a problem with the system is actuaily simply a mistaken operation. Check the following points once more before requesting
arvicing.
:
Check that the power cord, remote control cords, speaker cords, audio cords and antenna cords are properly connected.
Check that the A/V source is set properly.
Check that the DIRECTION MODE switch is set properly.
»
,
r
U
i)
Check that the REC OUT buttons and the REC OUT VCR1 switch are set properly.
Check that the EQ 1 and EQ 2 SELECT buttons are properly set.
Check that the MODE buttons are properly set.
Possible Cause
Corrective Action
" |
Influence from a motor, fluorescent light, or TV
Move the set away from the source of the noise.
Symptom
AM Broadcasts
Noise in the sound.
Humming noise.
FM Broadcasts
Crackling noise inthe sound.
Stereo reception is not possible
(noise).
Tape Playback and Recording
Tape does not move.
Sound is distorted.
Recorded sound is not clear, or
previous recording can be
heard.
Recording mode cannot be set.
CD Playback
Disc does not play.
Timers
Timer playback or recordin
does not function.
;
System
No sound is produced:
Noise over the power cord
Move the power cord away from the AM antenna.
Change the direction of the set.
Influence from car engines being ignited
Set the external FM antenna away fromthe road and
as high as possible.
:
,
Signals are weak.
Use an external FM antenna.
The PAUSE button has been pressed
Press the PAUSE button again.
Tape has reached the end
Rewind the tape.
Tape is damaged.
:
Use a different tape.
Head, capstans, or pinch rollers are dirty.
Clean the head area.
Head is magnetized.
Demagnetize the head.
Recording/playback head is dirty.
Erasing head is dirty
Clean the head area.
Set disc with the labelled surface facingup.
-
Tape's accidental erasure prevention tabs have
Apply adhesive tape over the holes.
been broken off.
Disc is set upside-down.
Disc is extremely dirty.
If buttons do not function. . .
Fixing screw has not been loosened.
Clock is not set to the proper time.
The "TIMER PLAY" or "TIMER REC" indicator is off.
The indicator on the amplifier's VOLUME control is
flashing (mute mode).
Speaker cords are not connected praperly (+ and
— sides), activating the protective circuit.
Wipe off the dirt.
Press the PAUSE (or PLAY) button.
urn the power off once, then back on.
~
Turn the screw approximately 1/4 turn clockwise.
Set the proper time.
Press the TIMER PLAY or TIMER REC button to turn
the indicator on.
Press the MUTE button on the remote contro! unit.
Turn the power off and connect properly.
f there should be a problem with the system, disconnect the power cord and contact your store of purchase immediately.
Advertisement
