Operation - MULTIQUIP Mikasa MT77HFR Operation Manual

CAUTION
Failure to understand the operation of the rammer could
result in severe damage to the unit or personal injury.
INITIAL STARTUP
When starting the MT77HFR rammer perform the following:
1. Open the fuel shut-off valve by moving the lever to the
ON (open) position (Figure 8).
FUEL SHUT-OFF
VALVE LEVER
Figure 8. Fuel Shut-Off Valve
2. Set the engine ON/OFF switch to the ON (start) position
(Figure 9).
ENGINE SWITCH
Figure 9. Engine Switch
3. Close the choke lever (Figure 10) and move the throttle
lever to the "Full Open" position. Turning the choke
lever 90° clockwise closes the choke. In cold weather,
start the unit with choke fully closed. In warm weather
or when the engine is warm, the unit can be started
with choke halfway or completely open.
MT77HFR RAMMER • OPERATION MANUAL — REV. #1 (07/08/20) — PAGE 17
"OFF"
(CLOSE)
"ON"
(OPEN)
ON
CHOKE LEVER
"OPEN"
Figure 10. Choke Lever
4. Grip the starter rope handle (Figure 11) and pull it
until you feel a slight resistance. Then pull sharply and
quickly. Return the handle to the starter case before
releasing.
Figure 11. Recoil Starter
5. If engine fails to start, move the choke lever (Figure 10)
to the half open position to avoid flooding.
6. Repeat steps 1 thru 5.
7. If the engine does not start after repeated attempts,
check the spark plug for excess fuel. Clean and replace
the spark plug as needed.

OPERATION

"CLOSE"
STARTER HANDLE
RECOIL STARTER