Table of Contents
Advertisement
Machine Safety Decal
The Mix N' Go mixer is equipped with an operation and safety decal (Figure 1). This decal is provided for operator safety
and maintenance information. The illustration below shows the decal as it appears on the machine. If the decal becomes
unreadable a replacement decal can be ordered from the MQ Parts Dept.
BATTERY CHECK
BATTERY CHARGE
STATUS INDICATORS
4
FULLY CHARGED
5
RECHARGE
1. Unplug power cord from controller,
that connects to battery.
2. Place key switch in ON position.
3. Next, press battery power ON button.
4. Verify battery status.
5. If RED battery status indicator is lit, recharge battery.
Reconnect controller power cord to battery.
PROTECTION
115°F
(46°C)
PAGE 10 — MIX N' GO MIXER MC3PBAT • OPERATION MANUAL — REV. #0 (04/09/24)
3
ON
2
POWER
CORD
1
CONTROLLER
CLIMATE
MAINTENANCE
Replace gearbox oil every 6 months.
Refill with:
40°F
(4°C)
Check drive belt once a year.
Figure 1. Machine Operation/Safety Decal
OPERATION AND SAFETY DECAL
STARTING MIXER
ON
1. Place key switch in the ON position.
2. Next, verify that drum begins to rotate.
SAE 80W-90, API GL-5
3.7~4.0 oz.
(110 ~120 ml)
STOPPING MIXER
ON
1. Place key switch in the OFF position.
2. Next, verify that drum stops rotating.
CLOCKWISE
READ MANUAL
MIXER
STOPPED
WARNING
To avoid injury
you MUST read
and understand
operator's manual
before using this
machine.
This machine to
be operated by
qualified
personnel only.
Ask for training
as needed.
DCL251BAT
Advertisement
Table of Contents
