Operation - MULTIQUIP MB25A Operation And Parts Manual

SELECTION AND INSTALLATION OF ROLLER AND
COLLAR
WARNING
Keep fingers from the bending area. Moving parts can
cause serious injury.
Do not drop anything into the machine from the bending
area as this may damage the machine.
1. Select the roller and corresponding collar to match the
diameter of the rebar to be bent. See Table 2 for the
different combinations.
2. Apply multi-purpose grease to the roller.
3. Install the collar and the roller as shown in Figure 2.
Figure 2. Roller and Collar Installation
4. When using a roller with a bearing, bearing must face
downward.
5. When using a collar with a bearing, bearing must face
downward.
6. To prevent the roller and the collar from coming off,
attach the washer securely with the bolt.
7. Position the stopper so that rebar to be bent is parallel
to the front of the stopper and tighten the rebar securely
in place. If the rebar is not parallel to the front, the
bending angle will be incorrect. See Figure 3.
PAGE 10 — MB25A REBAR BENDER • OPERATION AND PARTS MANUAL — REV. #3 (11/18/08)
REBAR
CORRECT
STOPPER
Figure 3. Stopper Position
8. Rotate the Angle Select Dial to the desired angle that
the rebar is to be bent (Figure 4). If the selected angle
cannot be obtained by the Angle Select Dial, "fine tune"
the angle by using the Angle Adjusting Knob (Figure 5).
ANGLE SELECT DIAL
Figure 4. Selecting the Bending Angle
ANGLE ADJUSTING KNOB
(+)
Figure 5. Fine Tuning the Bending Angle
9. Plug the power cord into a proper single-phase power
source. Make sure that the rebar bender is properly
grounded.
10. Turn the power switch on.
11. Hold the rebar firmly and press the Start Switch. This
will engage the clutch and the roller to bend the rebar.
12. After the rebar is bent to the desired angle, the roller
will automatically spring back to the starting position.

OPERATION

WRONG
90º
135º
45º
180º
(-)