Operation - MULTIQUIP MC64SH Operation And Parts Manual

MIXING
1. To position the tub, make sure the mixer is placed
on firm level ground, then pull up on the dump latch
(Figure 23) and turn the hand wheel until the tub is
at the desired position. Once the tub is at the desired
position, pull down on the dump latch to lock the tub
in position.
Figure 23. Mixing Drum Positioning
CAUTION
NEVER stand in front or behind the mixing drum while
it is being placed in the dump position. Stay clear of the
mixing drum while it is being positioned.
2. As the drum rotates, use a shovel (Figure 24) to place
the cement mix inside the drum, add water as required.
Be careful to only place the tip of the shovel inside
the drum.
PAGE 26 — MC64S/P CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #10 (08/30/19)
Figure 24. Filling Mixing Drum (CORRECT)
3. Placing the shovel all the way inside the drum (Figure 25)
will cause the shovel to strike the blades. This condition
will make the shovel rotate, and could cause injury to
personnel. NEVER place hands inside the mixing drum
while it is rotating.
Figure 25. Filling Mixing Drum (WRONG)

OPERATION