Front I/O Assembly - HP 200 G1 ST Maintenance And Service Manual

Front I/O assembly

The front I/O assembly is attached to the front of the chassis with one screw. Pull the assembly away from the
chassis to remove.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Remove the cables from the clip built into the basepan (1).
5. Disconnect the cables from the system board as follows:
(2) White connector labeled F_USB1
(3) White connector labeled F_USB2
(4) Yellow connector labeled F_AUDIO
Note the orientation of how the cable fits onto the left four pins of F_USB2 connector.
6. From the outside, front of the computer, remove the Torx screw (1) that secures the assembly to the
front of the chassis.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 26).
15).
14).
Front I/O assembly 31