Sony IPELA NSR-1200 User Manual page 43

Password
Enter the password for connecting to the device.
Serial No.
This displays the serial number of the device.
Version
This displays the firmware version of the camera.
Mac Address
This displays the MAC address of the device.
Network
This displays the network in which the device is
corrected.
Caution
The user name and password for a device cannot be
changed from NSR. To change them, access the device
directly from a Web browser. For details, refer to the
instruction manual of the device to be used. If you
change the user name and password for a device
registered to NSR, you must also change the
configurations in NSR.
Registration
This registers the devices with check marks to NSR, and
closes the dialog box.
Cancel
This cancels the registration and close the dialog box.
Setting Items of Input All Dialog Box
This dialog box allows you to simultaneously configure
the same setting values to multiple selected devices for the
following setting items when registering devices detected
via automatic search.
It is displayed by clicking [Input All] in the Multiple
Camera Registration dialog box (page 42).
Select the check boxes of the items you want to set, enter
the setting values, and click [OK].
User Name
Enter the user name for connecting to the device. It can be
up to 32 characters and consist of alphanumeric characters.
Password
Enter the password for connecting to the device. It can be
up to 32 characters and ASCII characters (upper or lower
case alphanumeric characters and symbols (! " # $ % & ' (
) * + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ~)).
IP Address
Enter the IP address for the device.
When registering multiple devices simultaneously, IP
addresses are configured sequentially, starting with the
entered address.
Port No.
Enter the port number on the device side for when
connecting with the device.
The default setting is "80."
OK
This reflects the setting values in the device list of the
Multiple Camera Registration dialog box, and closes the
dialog box.
Cancel
This cancels your settings, and closes the dialog box.
Setting Items of Add Device Dialog Box
Enter the setting items when registering a device manually.
This dialog box is displayed by clicking
Device Configuration screen (page 41).
After configuring each item, click [OK].
Caution
Only the name can be configured for analog cameras.
Device Type
Select the model name for the camera.
Normally, select "Auto Connect."
When setting this manually, select the model name.
Note
Model names for cameras that have never been registered
before will not appear for the SNC-XX600 series.
(Add) on the
43
Registering Devices