Table of Contents
Advertisement
7.3 Memory
Touch one of the buttons Memory to
memorise a programme or to set a
memorised programme.
Memorise a programme:
1. Press button Auto Off to activate the
appliance.
2. Turn the programme knob to your
favourite programme.
3. If it is necessary, set one or more
functions.
4. Touch and hold one of the buttons
Memory for some seconds.
The buzzer sounds and the display shows
that the programme is saved.
Set a memorised programme: Touch
the button where you memorised the
programme you want to set.
The programme indicator comes on and
the display shows all the information.
To cancel a memorised
programme you can only
memorise a new
programme.
7.4 Start/Pause
Touch button Start/Pause to start or
interrupt a programme.
7.5 Delay Start
Touch button Delay Start to delay the
start of a programme from 30 minutes to
20 hours.
7.6 Time Save
Touch button Time Save to decrease the
programme time.
You can select:
• SHORTENED DURATION: to wash
items with daily soil.
• EXTRA QUICK: to wash quickly items
with almost no soil.
Some programmes accept
only one of these functions.
7.7 Extra Rinse
Touch button Extra Rinse to add rinsing
phases to a programme.
Use this function for persons allergic to
detergents and in areas where the water
is soft.
7.8 Stains/Prewash
Touch this button to set one of the
following functions:
•
Prewash
Use this function for heavy soil. The
appliance adds a prewash phase to
the main wash. The programme
duration increases.
•
Soak
Use this function for heavy soil. The
appliance soaks the laundry at 30°C
for about half an hour before to wash.
•
Stains
Use this function for laundry with hard
stains to remove. When you set this
function, put the stain remover into
compartment
The programme duration
increases. This function is
not available with a
temperature lower than
40° C.
7.9 Spin
Touch button Spin to:
• Decrease the maximum speed of the
spin phase of the programme.
The display shows only
the spin speeds available
for the set programme.
• Deactivate the spin phase ( 'No spin'
function).
• Activate the Rinse Hold function.
Set this function to prevent fabric
creases. The appliance does not drain
the water when the programme is
completed.
7.10 Temp.
Touch this button to change the default
temperature.
Symbols
and
ENGLISH
15
.
= cold water
Advertisement
Table of Contents
