Table of Contents
Advertisement
All manuals and user guides at all-guides.com
Replacing the touch pad
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
For more safety best practices, see the Regulatory Compliance home
page at www.dell.com/regulatory_compliance.
Procedure
1
Using the alignment posts on the palm rest, place the touch pad on the palm-
rest assembly.
2
Align the screw holes on the touch-pad bracket with the screw holes on the
palm-rest assembly.
3
Replace the five screws (M2x3) that secure the touch-pad bracket to the
palm-rest assembly.
4
Slide the touch-pad cable and touch-pad buttons cable into their respective
connectors on the touch pad and close the latches to secure the cables.
5
Slide the touch-pad cable into the connector on the system board and close
the latch to secure the cable.
Post-requisites
1
Replace the battery.
2
Replace the
computer
3
Replace the
rear-I/O
4
Replace the
solid-state
5
Replace the
wireless
6
Follow the procedure from step 4 to step 7 in
7
Replace the
base
computer. After working inside your
base.
cover.
drive.
card.
cover.
After working inside your
"Replacing the hard
computer.
drive".
85
Advertisement
Table of Contents
