All manuals and user guides at all-guides.com
Removing the coin-cell battery
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
For more safety best practices, see the Regulatory Compliance home
page at www.dell.com/regulatory_compliance.
CAUTION: Removing the coin-cell battery resets the BIOS setup
program's settings to default. It is recommended that you note the BIOS
setup program's settings before removing the coin-cell battery.
Prerequisites
1
Remove the
base
2
Follow the procedure from step 1 to step 4 in
3
Remove the
wireless
4
Remove the
solid-state
5
Remove the
rear-I/O
6
Remove the
computer
Procedure
1
Disconnect the coin-cell battery cable from the system board.
2
Peel off the tape that secures the coin-cell battery cable to the system board.
3
Peel off the tape that secures the coin-cell battery to the palm-rest assembly.
4
Note the cable routing and remove the coin-cell battery cable from the
routing guide on the palm-rest assembly.
44
computer. After working inside your
cover.
card.
drive.
cover.
base.
After working inside your
"Removing the hard
computer.
drive".