Notes And Precautions - Oki MC760 Maintenance Manual

3.1 Notes and precautions

• Do not set it in any high-temperature locations or near any heat sources.
• Do not set it in a place where the chemical reaction may occur (laboratory etc.).
• Do not set it near any liquid that may ignite such as alcohol and thinner.
• Do not keep it out of reach of children.
• Do not place it on an unstable or uneven surface
(unstable table and slanting place, etc.).
• Do not put it in direct sunshine. And do not put it in a moist or dusty place.
• Do not set it in wet or corrosive environment.
• Do not set it in a place where may cause vibration.
• If the MFP is dropped down or the cover is damaged, please pull out the power plug
from the outlet and contact the customer center.
This may cause an electric shock, fire, injury.
• Please read this manual carefully before connecting the power supply cable, printer
cable, ground cable.
This may cause fire.
• Do not insert any foreign objects into the vent hole.
This may cause an electric shock, fire, injury.
• Do not put a vessel(s) filled with water on the MFP.
This may cause an electric shock, fire.
• Do not touch the fuser unit when you open the cover of the MFP.
It is hot and could cause burns.
• Do not throw the toner cartridge, the image drum cartridge into the fire.
It may cause burns due to dust explosion.
• Do not use inflammable sprays near the MFP.
It may cause fire because some parts in the MFP may become very hot.
• If the cover becomes abnormally hot, smoke rises, it smells strange or it sounds
abnormal, please pull out the power plug from the outlet and contact the customer
center.
It may cause fire.
• If the liquid such as water enters the MFP, please pull out the power plug from the
outlet and contact the customer center.It may cause fire.
• If you drop the foreign objects such as clip in the MFP, please pull out the power plug
from the outlet and take the foreign objects out.
This may cause an electric shock, fire, injury.
• Do not disassemble the MFP unless following the correct procedure written in the
manual.This may cause an electric shock, fire, injury.
• Do not set it in a place where the vent hole of the MFP is blocked.
• Do not set it directly on heavy wool or shag carpet.
• Do not place it in locations of poor ventilation such as enclosed areas.
• Give particular attention to adequate ventilation care when using it continuously in a
narrow room for a long time.
• Do not place it close to strong magnetic fields and noise source.
• Do not place it next to the monitor and television.
• Hold tightly the both sides of the MFP when you move the MFP.
• Because the weight of the MFP is approximately 60kg (in a state of packing), it
needs more than two adults to lift it up.
• Do not come close to the paper exit part while printing.
This may cause injury.
Please explain the safety precautions about installation and handling with showing the
all precautions in user's manual to customer. Especially, the details about power supply
cable and the ground cable must be explained completely.
3. Set up
46 /