When Receiving No Reply - Icom ID-50A Basic Manual

D-STAR OPERATION

■ When receiving no reply

To communicate through the repeater, your signal must access to the repeater. The
following chart is designed to help you correct problems which are not equipment
malfunctions.
 "AM" indicates the PDF type Advanced manual.
PROBLEM
After your call, the
repeater does not
return a status reply.
After your call, the
repeater replies 'UR?'
and its call sign.
After your call, the
repeater replies 'RX' or
'RPT?' and the access
repeater's call sign.
After your call, the
repeater replies
'RPT?' and the access
repeater's call sign.
After your call, the
repeater replies 'RPT?'
and the destination
repeater's call sign.
Even holding down
[DR], the DR screen is
not displayed.
63
POSSIBLE CAUSE
The repeater setting is
wrong.
Your transmission did not
reach the repeater.
The call was successfully
sent, but no station
immediately replied.
Your own call sign (MY) has
not been set.
Your own call sign (MY)
has not been registered on
a gateway repeater, or the
registered contents do not
match your transceiver's
settings.
The call sign of the
destination repeater is
wrong.
The repeater cannot connect
to the destination repeater.
The repeater is busy.
There is no repeater list in
your transceiver.
The Lock function is
activated.
SOLUTION
Select the correct repeater.
Correct the repeater
frequency, frequency offset,
or duplex settings.
Wait until you are closer to
the repeater and try again.
Try to access another
repeater.
Wait for a while, and try
again.
Set your own call sign (MY).
Register your own call sign
(MY) on a gateway repeater,
or confirm the registration of
the call sign.
Correctly set the destination
repeater call sign.
Check the repeater settings.
Wait for a while, and try it
again.
Import the repeater using a
microSD card.
Directly enter the Repeater
list data into the transceiver.
Hold down [ ] for 1
second to turn OFF the Lock
function.
REF.
p. 49
—
—
—
—
p. 43
p. 45
—
—
p. 64
AM
p. 20