Kenwood XD-750 Instruction Manual page 54

CD player
EO
x dai an ts be
ACD is placed in the player but it cannot | The disc is placed upside down, @Place the disc properly, with the label side -(78]
be played. facing upward i
eThe disc position is displaced. @Place the disc properly 118)
eThe disc is extremely dirty eCiean the disc referring to "Disc handling 5...
precautions"
The disc is scratched. eTry another disc
Dew is condensed on the optics lens. e@Refer to "Beware of condensation" and
remove tne condensation by evaporation
Sound is not produced. e@The disc has not been placed. e Place a disc in the CD player
eThe player is not put to the play mode Press the play key.
The dise is extremely dirty. @Cloan the dice referring ta "Dise handling
precautions".
@The disc is scratched. eTry another disc
Sound skips. eThe disc is dirty. eClean the disc referring to "Disc angling
precautions"
The disc is scratched. eTry another disc
The player is subject to vibration elnstall the unit in a piace not subject to
vibrations.
a malfunction.
os 1. With some tapes, a squeaky noise is produced when the tape is stopped automatically. This is due to the tape protection function, and not
2. Do not use longer tape than 110 minutes tapes, for the tape is too thin and gets easily tangled
For the US.A. For the USA.
CAUTION: Note to CATV system installer:
Use of controls or adjustments or performance of procedures This reminder is provided to call the CATV system installer's
othar than thasa specified herein may result in hazardous radia- attention to Article 820-40 of the NEC that provides quidelines
tion exposure. for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the build-
In compliance with Federal Regulations, following are reproduc- ing, as close to the point of cable entry as practical.
tions of lables on, or inside the product relating to laser product
safety. ,
a a eg 4
Pr | KENWOOD CORPORATION
290 /-3, ISHIKAWA-CHO,
| HACHIOJI-SHI,
| TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS EQUIPMENI
| CONFORMS TO DHHS REGULATIONS NO. 21 CFR
| | 1040. 10, CHAPTER |, SUBCHAPTER J.
SSS eS Se Se
Location: Back Panei
For the US.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference
unless the modifications are exoresslv approved in the instruction manual. The user could lose the authority to operate this equipment if
an unauthorized change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference In a residential Installation. This equipment may
cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is
No guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by ono or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-~- Consult the dealer or an experienced radio / TV technician for hetp.