Kenwood XD-750 Instruction Manual page 27

XD-750/700/550/550 (En)
Selection of the reverse mode Selection of DOLBY NR (Noise Reduction}
REV. MODE The Dolby NR system minimizes the hiss noise heard when
Karas © playing tape. When playing a tape prerecorded with Dolby
NR ON, be sure to set the DOLBY NR ON for playback.
r Each press switches the modes as follows.
@ "x>"... Both sides are played back (recorded), and
then the tape stops.
@ "ct>" .. Both cides are played back ondlecely.
(The tape stops after recording onto both Lit when "DOLBY NR" is ON.
sides.)
® "zt" .. Only one side is played back (recorded), DOLBY NR pexecs |
and then the tape stups.
"Sa
T a or
7 Keown B
To end recording
REC/ARM
Re;
@Pressing the key pauses recording after leaving a non-recorded
space of about 4 seconds. cf @ "DOLBY NR" ON...... DOLBY NR is used.
eif the key is pressed again in less than 4 seconds after it has been @ "DOLBY NR" OFF..... DOLBY NR is not used.
pressed, recording resumes from that instant.
Each press switches the modes as follows.
4. Select the source to be recorded.
The input source component to be recorded shoul be displayed.
ur th fap rams
aa | a ae Wut 4
> Ge > DD neve
eWhen the CD input is selected and if a disc
has been set in the CD player, its playback
. Seloct an input eoures other than "TAPE". starts Immediately
5. Start recording.
@ Play (or tune) the input source to be
REC/ARM recorded. = aa, ——
2 CG Start recording. crt of 3628 %
a ie p> tex Zh) atv. moor
@ Recording stops automatically when the tape Lights
side(s) to be recorded have been fully recorded.
= The beat cancel function can be used when
recording AM broadcasts (28)