Table of Contents
Advertisement
RX-504VBK/RX-504VLBK
RX-505VTN/RX-505VLTN
COMPU
LINK Remote Control System
JVC's exclusive
''COMPU
LINK' remote contro} system connects
equipment with JVC COMPU
LINK-1/SYNCHRO terminais to the re-
mote contro! system. The equipment can be controlled from the re-
mote
control
unit, or other
functions
(such as automatic
source
selection and synchronized recording) can be used.
# Automatic
source selection
Pressing SOURCE
keys will automatically
put the corresponding
source equipment into the PLAY mode. When the PLAY key on source
equipment is pressed, the corresponding SOURCE
key is automati-
cally set to that source. Other source equipment shuts down about
5 seconds later.
™ Synchronized recording
Synchronized recording permits a tape deck to start recording auto-
matically in synchronism with a CD piayer or turntable. Set the tape
deck in the REC/PAUSE
mode and press the PLAY key on the CD
player or turntable. The tape deck will enter the recording mode au-
tomatically, starting synchronized
recording.
Synchronized recording stops automatically after the CD player or
turntable has stopped and the tape deck has entered the REC/MUTE
mode for about 4 seconds.
For details, refer to the tape deck in-
structions,
fPYAADI TT IATL
WoWIWET WS Enll CEN
Il!/Remotfe //Il
Control System
Notes:
® COMPU
LINK remote control does not work on the tape deck con-
nected to the TAPE 2 terminals.
lf you connect 4 tape deck to the TAPE 2 terminals, disconnect
the remote contro! cable.
® if the power for any connected equipment is shut off during syn-
chronized recording, the system will not operate properly. In this
case, you must Start all over again.
® During synchronized recording the SOURCE key will lock in either
the CD or PHONO position. This is to prevent you from acciden-
tally stopping the recording or changing to any other source. To
change
to another
source
you
must
first stop synchronized
recording.
@ |f you program track numbers on a CD player or CD atuo-changer
and use synchronized recording, a blank space about 4 seconds
ong will be left between recordings. This permits music scanning.
Inserting Batteries in the Remote Control Unit
The RM-SR505U
remote contro! unit require two size AAA
(1.5 V)
batteries.
important Notes About Batteries
@
If the range of the remote control unit seems shortened,
the bat-
teries may be old. Try inserting new batteries.
@ Observe
the polarity of the batteries when
loading them
Do not use one new
battery with one old batteries.
®
Be sure to use batteries of the same
brand.
Batteries may vary
in voltage even through they look alike.
®@ |f the remote control unit will not be used for a long time, remove
the batteries.
CAUTION:
Do not heat batteries or attempt to dispose of them
by burning.
1-18 (No.20220)
1. Remove the rear cover of the remote control unit by pressing
down gently while sliding it out
|
2. insert the batteries, making sure that their position matches
that of the diagram inside the remote
3. Replace the rear cover
16
Advertisement
Table of Contents
