Using The Mounting Bracket Air-Accpmk3700-2 - Cisco Catalyst IW9167I Hardware Installation Manual

Installation Overview
1 Access point
2 M6 bolts and washers
Note Ensure that the access point is firmly secured to the mounting bracket.
You can use the keyholes for "hands-free" installation. Ensure that you torque the nuts to 6 to 7 ft-lbs.
Caution Never leave the access point unattended if the mounting hardware is not torqued to full value.

Using the Mounting Bracket AIR-ACCPMK3700-2=

The mounting bracket AIR-ACCPMK3700-2= supports poles from 2 to 16 inches in diameter. To mount the
access point on a pole using this mounting bracket:
Step 1
Assemble two strap brackets on the pole clamp bracket that are positioned for the pole diameter you are using to mount
the access point. The following image illustrates the pole diameter indicators and bolt holes on the pole clamp bracket.
3
4
Cisco Catalyst IW9167I Heavy Duty Access Point Hardware Installation Guide
Using the Mounting Bracket AIR-ACCPMK3700-2=
Pole mounting bracket
2"– 3.2" (5–8 cm) diameter pole
25