Connecting To The Rj45 Port Using M12 Adapter - Cisco Catalyst IW9167I Hardware Installation Manual

Connecting to the RJ45 Port Using M12 Adapter

1 RJ45 cable
2 Gasket
3 PG13 body
Step 2
Plug the RJ45 cable into the RJ45 connector in the chassis.
Step 3 Thread the PG13 body (with gasket) into the chassis. The PG13 must be screwed into the chassis at this point.
Step 4
Insert the grommet into the ferrule, and press it into the PG13 body.
Step 5 Tighten the clamp nut onto the PG13 body until the grommet compresses onto the RJ45 cable.
1 SFP port connected using cable gland
2 RJ45 port connected using cable gland
Connecting to the RJ45 Port Using M12 Adapter
Follow these steps to connect to the RJ45 port using M12 adapter:
Step 1 Ensure the O-ring is on the M12 adapter.
Cisco Catalyst IW9167I Heavy Duty Access Point Hardware Installation Guide
40
4 Grommet
5 Ferrule
6 Clamp nut
3 DC power port connected using cable gland
Installation Overview