Connecting To The Dc Power Port Using Cable Gland - Cisco Catalyst IW9167I Hardware Installation Manual

Connecting to the DC Power Port Using Cable Gland

Step 3
Connect a shielded outdoor-rated Ethernet (CAT5e or better) cable between the power injector and the AP's PoE-in
connector.
Step 4 Connect the Ethernet cable to the AP PoE-In port.
Connecting to the DC Power Port Using Cable Gland
Follow these steps to connect to the DC power port using cable gland:
Step 1
Disassemble PG13 cable gland and slide parts over DC cable in the order shown in the following figure:
1 DC cable
2 Gasket
3 PG13 body
Step 2
Plug 4P connector cable into the DC connector in the chassis.
Step 3 Thread the PG13 body (with gasket) into the chassis.
Step 4
Insert the grommet into the ferrule, and press it into the PG13 body.
Step 5 Tighten the clamp nut onto the PG13 body until the grommet compresses onto the DC cable.
Cisco Catalyst IW9167I Heavy Duty Access Point Hardware Installation Guide
36
4 Grommet
5 Ferrule
6 Clamp nut
Installation Overview