MAINTENANCE
FLUORESCENT LIGHT REPLACEMENT
If both ends of the fluorescent light are blackened or flickering, the light is worn out. Replace it.
CAUTION
f you have been using the projector, the fluorescent light will be very hot, and may cause burn injuries. Wait for the fluorescent
|
light to cool before replacing it.
Unplug the power cord.
Install a new fluorescent light.
Remove the cover pressing the
clips on it.
Turn the light 90° after inserting it.
Reinstall the cover.
8] Rotate the fluorescent light and
pull out the light towards you.
|
Fit it on as shown in the drawing.
MAINTENANCE
Notes]
* Use FL-4N for the fluorescent light.
+ Even with a good fluorescent light, flickering may occur. In such a case, if you switch off, wait for a short while, then switch on
again, the flickering should go away. (If the light blinks a few times or the flickering stops after the light is on for a few minutes, this
is not a problem.)
38