Toshiba TLP510 Owner's Manual page 13

Installing Batteries
Install batteries to enable remote control operation.
Open the cover.
Make sure that the +/— polarities match the illustration in
the compartment.
Attach the cover.
Using batteries incorrectly can cause them to leak or burst. Strictly observe
the following.
Install the batteries with their + and — ends facing correctly.
Do not cnarge, heat, disassemble, or short the batteries or throw them
into a fire.
Do not leave exhaust batteries in the remote control.
Do not mix different types or batteries or new and old batteries.
When you will not be using the remote control for a prolonged period,
take the batteries out of the remote control.
When the remote control stops working or only works from very close
distance, replace all the batteries with new ones.
When replacing the batteries, use a more longer life alkaline batteries.
Ifa battery leaks, carefully wipe off any residue inside the battery case
before loading new batteries.
Remote Control Operation
Instruction to use the remote control.
BEFORE USE
Face the main unit and press a
remote control button.
hse
3 BI
'
a
Rear side of the Document
imaging camera model
DOCUMENT CAMERA
©
Distance : within about 5 meters from the front of the
remote sensor.
within about 15° of the remoter sensor in every
direction.
« The remote control may not operate when there is
sunlight or other strong light such as a fluorescence
lamp shining on the remote sensor.
Angle :
Keep strong light off the remote sensor.
Operate the remote control from a position where the remote sensor is
visible.
Do not drop the remote control or otherwise jolt i
Keep the remote control out of locations with excessively high tempera-
ture or humicity.
Do not get water on the remote control or place wet objects on it
Do not disassemble the remote control.
12 ==