17 mm (11/86 inch)
2 Fold back the woven wire.
3 Strip 12 mm (1/2") of the white plastic casing,
leaving 12 mm of the center conductor.
12 mm (1/2 inch)
4 Slip the crimping ring over the cable.
§ Insert the inner conductor into the F-type
connector shaft and push the end of the cable
F-type connector
into the connector as far as it will go.
6 Slide the crimping ring over this assembly.
Pinch the crimping ring with pliers to hold the
connection in place.
| 7 Cut the center conductor leaving 3 mm (1/6")
3 mm (1/6inch)
from the end.
8 Insert the F-type connector into VHF/UHF IN plug
on the VCR.