Table of Contents
Advertisement
INSERTING THE BOBBIN
5. Push the spindle towards the bobbin winder
1. Remove the bobbin cover plate and place the
stop, to engage the bobbin winding
bobbin into the bobbin holder with the thread
mechanism.
running counter-clockwise.
6. Hold the end of the thread and press on the
2. Draw the thread into the notch (A).
foot control to start the machine.
3. Draw the thread clockwise until it slips into the
7. After the bobbin winds a few turns, stop the
notch (B).
machine and cut the thread near the hole.
4. Pull the thread about 15 cm (6") from the bobbin
Start the machine again.
and attach the bobbin cover plate.
8. The bobbin winder will stop by itself when the
bobbin is full. Push the bobbin and spindie to
the left. Remove the bobbin from the spindle
and cut the thread.
ENFILAGE DU FIL INFERIEUR
lorsqu'elle sera pleine. Pousser ia canette a
gauche et la retirer. Couper le fil.
11
Advertisement
Table of Contents
