Table of Contents
Advertisement
Please note:
•
The first time you use the appliance, you need to make
4-5 cappuccinos before the results in the cup will be
satisfactory.
•
The first time you use the machine, the water circuit is
empty and the appliance could be very noisy.The noise
becomes less as the circuit fills.
•
After turning the appliance on for the first time, remove
the spout (C7) and store safely. You will need it to perform
certain maintenance operations on the appliance.
4. TURNING THE MACHINE ON U
Please note:
•
Before turning the appliance on, make sure the main
switch (A7) is pressed (fig. 2).
•
Each time the appliance is turned on, it performs an auto-
matic preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this
cycle.
5. TURNING THE APPLIANCE OFF
Whenever the coffee machine is turned off after being used to
make coffee, it performs an automatic rinse cycle.
7. Press "OK" to fill the water
circuit: the appliance
delivers water from the
spouts (fig. 9);
8. At the end of delivery, the
appliance proceeds with
heating by performing
a rinse cycle, delivering
hot water from the coffee
spouts (A14). When at
temperature, the appli-
9
ance proposes an intro-
ductory video explaining
the home page (B).
1. To turn the appliance on,
press the
(A9) (fig. 10): the appli-
ance comes on;
2. When at temperature,
the appliance performs
a rinse cycle delivering
hot water from the coffee
spouts (A14). As well as
heating the boiler, this
also heats the internal
10
circuits by circulating hot
water.
1. To turn the appliance off, press the
10).
2. If envisaged, the appliance performs a rinse cycle, deliver-
ing hot water from the coffee spouts (A14), then goes off
(stand-by).
Please note:
If you will not be using the appliance for some time, unplug
from the mains socket:
3. Release the main switch (A7) at the back of the appliance
(fig. 2).
Important!
Never press the main switch while the appliance is on.
6. MENU SETTINGS U
6.1
Rinsing
Use this function to deliver hot water from the coffee/hot water
spouts (A14) (and, if inserted, the descaling spout (C7)), to clean
and heat the appliance's internal circuit.
Place a container with a minimum capacity of 100ml under the
spouts (fig. 8).
To enable the function, proceed as follows:
1. Press the settings menu (B6);
2. Select "Rinsing";
3. Press "OK" to start delivery: after a few seconds, hot water
is delivered to clean and heat the appliance's internal cir-
cuit (fig. 9);
4. To stop rinsing, press "Cancel" or wait for rinsing to stop
automatically.
Please note:
•
If the appliance is not used for more than 3-4 days, when
you turn it on again, we strongly recommend performing
2-3 rinses before use;
•
After cleaning, it is normal for the grounds container (A25)
to contain water.
button
6.2 Descaling
For instructions on descaling, see section "17. Descaling u".
6.3 Connectivity
Use this function to enable or disable connectivity. Proceed as
follows:
1. Press the settings menu (B6);
2. Select "Connectivity";
3. Press "Next";
4. Enable the Wi-Fi connection and remote control (via the
Delonghi Coffee Link App);
5. The appliance PIN, needed to connect by App, is displayed
on the screen;
6. Press "←" to save the new selection and go back to the
homepage (B).
7
button (A9) (fig.
Advertisement
Table of Contents
