Table of Contents
Advertisement
4.
After about a minute, 1, 2, 3 or 4 red squares appear, de-
pending on the hardness of the water.
Setting water hardness
Select the water hardness level on the display according to the
result of the measurement procedure described above, and
press "Ok".
The water hardness selected will be saved in the machine
settings.
Please note:
The water hardness can be changed directly from the settings
menu (see "6.10 Water hardness").
Installing the water softener filter
Certain models are fitted with a water softener filter (D4). If this
is not the case with your model, you are recommended to pur-
chase one from De'Longhi Customer Services.
1. The appliance prompts for installation of the filter: press
"Start" to proceed (to put the operation off, on the other
hand, press "Later").
2. Remove the water tank (A9) (fig. 2), fill to the MAX line
with fresh drinking water (fig. 3) and press "Next".
3. Remove the filter from the packaging and turn the date indi-
cator so that it shows the next 2 months (fig. 9); Press "Next".
2
Please note:
The filter lasts about two months assuming normal use of the ma-
chine; if on the other hand the machine remains idle with the filter
installed, it will not last more than three weeks, at most.
4. To activate the filter, run tap water through the hole in the
centre of the filter until water comes out of the openings at
the side for more than a minute (fig. 10); Press "Next".
5. Insert the filter in the water tank and immerse it completely
for about ten seconds, angling and pressing it lightly so that
the air bubbles can escape (fig. 11). Press "Next".
6. Insert the filter in the filter housing (fig. 12) and press it fully
home; press "Next";
0,5 L
9
7. Close the tank with the lid (A8);
8. Reposition the water tank in the machine and press "Next".
9. Position an empty container of at least 0.5 litres capacity
under the hot water spout (fig. 7) and press "Ok" to activate
the filter;
10. The appliance delivers hot water, then stops automatically.
11. The filter is now active and the machine can be used. Remove
the water tank, and refill it with fresh drinking water.
Now that all the technical aspects have been covered, press
"Start" to get to know the machine.
Setting profiles
1. Select the number of persons who will be using the ma-
chine. Press "Next".
2. The machine creates a profile automatically for each user:
to customize the profile, press
or "Profile" button). Having made the desired changes,
press "Save".
3. Press "Next".
4. Press "Start" to run a video tutorial.
5. At the end of the video, press "Start": the machine is ready
10
for use.
4. TURNING THE MACHINE ON
Please note:
•
Each time the appliance is turned on, it performs an auto-
matic preheat and rinse cycle which cannot be interrupted.
The appliance is not ready for use until the cycle has been
completed.
1. To turn the appliance on, press
appliance will switch on;
7
11
(press the "Change"
(B1)(fig. 13): the
12
Advertisement
Table of Contents
Troubleshooting
