Table of Contents
Advertisement
4. Press "←" to save the new selection and go back to the
homepage (B).
6.9 General
1. Press the settings menu (B6);
2. Select "General";
Here you can enable or disable the following functions with a
simple touch:
-
"Beep": when enabled, the appliance beeps whenever an
operation is performed.
-
"Energy saving": use this function to enable or disable en-
ergy saving. When enabled, the function reduces energy
consumption in compliance with European regulations.
When enabled, the
settings menu (B6).
6.10 Water filter
For instructions on the filter (C7), see section "19. Water softener
filter u".
6.11 Water hardness
For instructions on setting water hardness, see section "18. Set-
ting water hardness u".
6.12 Default values
This resets all menu settings and user customisation back to
the default values (with the exception of the language, which
remains as set, and the statistics).
Proceed as follows:
1. Press the settings menu (B6);
2. Select "Default values";
-
To reset the appliance to the default values, press "OK";
otherwise to reset the individual profile, press the arrow
to pass to the next screen, select the profile to reset and
press "OK";
3. Press "OK" again to confirm the reset to default values;
4. Press "OK" to exit the menu and go back to the homepage
(B).
Please note:
When the appliance (not the individual profile) has been reset
to the default values, the machine proposes the introductory
video again.
6.13 Emptying the circuit
To avoid the water in the circuit freezing if the appliance is to be
left idle for a long period of time, or before taking it to customer
services, we recommend emptying the water circuit.
Proceed as follows:
1. Press the settings menu (B6);
2. Select "Empty water circuit";
3. Press "OK" to start the guided procedure;
symbol appears on the icon in the
4. Empty the grounds container (A25) and drip tray (A24) (fig.
11), then press "Next";
5. Insert the spout (C7) on the milk container connector (A13)
(fig. 7);
6. Position a 0.5 litre container under the spout (fig. 8). Press
"OK";
7. The appliance performs a rinse cycle with hot water from
the spouts;
8. At the end of rinsing, remove the water tank (A20) (fig. 12)
and empty; if present, remove the water softener filter (C7)
from the water tank and press "Next";
9. Put the empty water tank back in the appliance and press
"OK";
10. Wait for the appliance to empty the circuit; (Important:
hot water from the spouts!). As the water circuit empties,
the appliance could become noisier. This is part of normal
operation.
11. When the circuit is empty, extract and empty the drip tray,
put back in the appliance and press "Next";
12. Press "OK". The appliance goes off (standby).
The next time the appliance is turned on, follow the instructions
in section "3. Setting up the appliance U".
6.14 Statistics
This displays statistics relating to the machine. To view the sta-
tistics, proceed as follows:
1. Press the settings menu (B6);
2. Select "Statistics". To display the information and scroll be-
tween screens, press "Next" or "Back".
3. Press "←" to go back to the homepage (B).
9
11
12
Advertisement
Table of Contents
