Star Trac 1000 Owner's Manual page 33

Chapter Ten
Troubleshooting
Should your Star Trac display an error code, record the error code and consult the following
chart for possible solutions. Should you require further assistance call your STAR TRAC
dealer or 800-535-4634. (Error messages can be cleared only by switching treadmill power
off.)
ERROR CODE
PROBABLE CAUSES
SOLUTION
"FS ERROR 0"
Fail-Safe Tripped
Power switch "OFF/ON"
cycled too fast.
Shut power switch "OFF,"
wait ten seconds, then turn "ON."
Faulty motor control board
Contact Unisen
Faulty display cable
Contact Unisen
Attempting to run after
executing watchdog trip
in motor test mode.
Shut power "OFF," wait ten (10)
seconds then turn "ON."
"FS ERROR 1"
Stuck key
Illegal key activated
Shut power switch "OFF," wait
ten seconds, then turn "ON."
"SPD ERROR 0"
Loss of feedback
while running
Disconnected speed sensor
Check speed sensor cable
Flywheel abrading speed
sensor cable
Repair or replace
sensor cable
Misaligned speed sensor
(relative to RPM sensor)
Reposition sensor
to read RPM disc
Faulty speed sensor
Replace speed
sensor cable
assembly
"SPD ERROR r
Sudden change in speed
greater than 2 mph
Misadjusted or faulty
motor control board
Contact Unisen
21