Warning Slope Angle - Inhibit Cut; Warning Slope Angle - Stop Cut; Warning Oil Pressure Fault - Jacobsen JMP653F Manual

5 CONTROLS
5.6.2 WARNING SLOPE ANGLE – INHIBIT CUT _________________________________
If the slope angle continues to increase the screen will display this
warning which indicates that the cutters will be prevented from
starting if not already running, or re-started if running then stopped.
An audible warning will be sounded 4 times at 4 second intervals.
This will continue until the machine has been driven to an area with a
shallower slope angle. The warning screen and the audible alarm will
self-clear as the vehicle angle decreases (i.e. the operator does not
need to press Button 4 to clear it). The angle at which this warning
occurs varies with machine configuration as follows:
• with ROPS – 22°
• with Cab – 20°
5.5.3 WARNING SLOPE ANGLE – STOP CUT ___________________________________
If the slope angle continues to increase the screen will display this
warning which indicates that the cutters have been switched off and
disabled. An audible warning will sound continuously for 4 seconds at
4 second intervals, and the red LEDs will flash continuously for 4 sec-
onds at 4 second intervals. This will continue until the machine has
been driven to an area with a shallower slope angle. The warning
screen and the audible alarm will self-clear as the vehicle angle de-
creases (i.e. the operator does not need to press Button 4 to clear it).
The angle at which this warning occurs varies with machine configu-
ration as follows.
The angle at which this warning occurs varies with machine
configuration as follows:
• with ROPS – 25°
• with Cab – 23°

5.6.4 WARNING OIL PRESSURE FAULT _______________________________________

When this screen is shown, the engine oil pressure has decreased below
the normal level. If this happens during operation, or does not go off when
the engine is run at more than 1000 rpm. Stop the engine and check the oil
level. Top up if necessary.
If the fault persists, do not use the machine at all and contact your local
Jacobsen dealer.
en-40
22
1/1
25
1/1
1/1