Visual Display; Startup Screen; Warning / Service Screen - Jacobsen JMP653F Manual

5.3 VISUAL DISPLAY _______________________________________________________

The visual display is activated when the ignition is turned on.

5.3.1 STARTUP SCREEN ____________________________________________________

When the Ignition Key is turned to the start position, this screen is shown.
The Hour Meter will show total hours of engine operation.

5.3.2 WARNING / SERVICE SCREEN __________________________________________

After the Start-up Screen the Warning Screen is
shown, the screen is visible for four seconds. If the
machine is within 5 hours of the next service, a
warning is shown. An operator input is needed to
continue to the Home Screen. If there is no input
needed, the main screen will become visible. If a fault
condition has occurred during the previous start, a
pop up screen will become visible over the top of the
warning screen. The operator must confirm the fault
before they can move to the Home Screen.
1
13
2
14
3
15
16
4
5 17
6 18
7
19
8
20
H O
2
21
9
22
10
23
11
24
12
1. Park Brake Engaged
2. DPF Inhibit
3. DPF Regeneration Request
4. DPF Regeneration Ongoing
5. TST™ Active (Optional
6. TST™ Not Active (Optional)
7 Cutter Indicator (Flashes if not in off position on start up)
8. Water In Fuel Warning
9. Transport Lock
10. Foot Pedal Warning (Flashes if not in neutral position on start up)
11. Seat Warning (Flashes if not occupied or disconnected on start up)
12. Fuel Indicator (Below bar graph)
13. Engine Temperature Indicator (Below bar graph)
14. Check Engine
15. Traction Boost / Weight Transfer
MODE
16. Engine Able To Start (Green)
A
17. Engine Unable To Start (Red)
18. Fan
M
19. Backlap
20. Mode (Selection Pop Up)
21. Automatic Mode
22. Manual Mode
23. Creep Mode
24. Cruise Control
WARNING
If incorrectly used this machine can cause
severe injury. Those who use and maintain
this machine should be trained in its proper
use, warned of its dangers and should
read the entire operators manual before
attempting to set up, operate,
adjust or service
the machine.
CONTROLS 5
2.5 Hours
1234 123.4 Hours
A
TM
MODE
en-23