CONTROLS 5
5.6 WARNING SCREENS____________________________________________________
When a fault, warning or hazard presents itself, the following screens are displayed.
5.6.1 SLOPE ANGLE DISPLAY _______________________________________________
During work, if the machine is driven on a slope of 16° the machine angle
will be displayed in the centre of the screen, until the machine has been
1234
123.4 Hours
driven onto an area of less than 16°.
16
TM
Note: Whilst in Transport Mode, the TST icon on screen will appear Red
with Cross, indicating TST is disabled.
!
CAUTION
While in Transport Mode the following audible alarms are disabled for TST™ functions:
Maximum Slope Angle Exceeded, Inhibit Cut and Stop Cut
en-39