Table of Contents
Advertisement
2
1
1. Engine oil drain bolt (crankcase)
2. Gasket
3. "
" mark
TIP
A "
" mark is stamped on the crankcase
●
near the engine oil drain bolt for easy iden-
tification.
Dispose of used oil according to local regu-
●
lations.
Skip steps 11–13 if the oil filter cartridge is
●
not being replaced.
11. Remove the oil filter cartridge with an oil
filter wrench.
1
1. Oil filter cartridge
TIP
An oil filter wrench is available at a Yamaha
dealer.
12. Apply a thin coat of engine oil to the O-
ring of the new oil filter cartridge.
Periodic maintenance and adjustment
3
1. O-ring
TIP
Make sure that the O-ring is properly seated.
13. Install the new oil filter cartridge with an
oil filter wrench, and then tighten it to the
specified torque.
Tightening torque:
Oil filter cartridge:
17 Nm (1.7 m·kgf, 12 ft·lbf)
14. Install the engine oil drain bolts and their
new gasket, and then tighten the bolts to
the specified torques.
Tightening torques:
Engine oil drain bolt (crankcase):
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Engine oil drain bolt (oil tank):
16 Nm (1.6 m·kgf, 12 ft·lbf)
15. Add 2.0 L (2.11 US qt, 1.76 Imp.qt) of the
recommended engine oil to the oil tank,
and then install and tighten the oil filler
cap and the cylinder head cap.
Recommended engine oil:
See page 122.
16. Start the engine, warm it up for several
minutes, and then turn it off.
17. Remove the oil filler cap, and then add
sufficient oil of the recommended type to
raise it to the "H" level mark on the dip-
81
Advertisement
Table of Contents
