Table of Contents
Advertisement
1. Shroud stay
Left and right side covers
To remove a side cover
1.
Remove the shroud. (See the above pro-
cedure.)
2.
Loosen the fasteners, pull outward on the
areas shown, and then slide the side cov-
er forward to remove it.
1
1. Fastener
2. Left side cover
To install a side cover
1.
Fit the projection on the rear of the side
cover into the hole in the fuel tank cover.
Periodic maintenance and adjustment
2
2.
Fit the projections on the side cover into
the slots as shown.
3.
Tighten the fasteners.
4.
Install the shroud.
Top cover (RS90P / RS90PLT)
To remove the top cover
1.
Remove the shroud and the left side cov-
er. (See the above procedures.)
2.
Disconnect the auxiliary DC jack coupler.
1
1. Auxiliary DC jack coupler
63
Advertisement
Table of Contents
