Table of Contents
Advertisement
Periodic maintenance and adjustment
3.
Remove the screws, and then remove
the cable guide.
1
1. Screw
2. Cable guide
4.
Loosen the quick fastener screws.
1. Quick fastener screw
2. Top cover
5.
Lift up the rear of the top cover, discon-
nect the main switch coupler, and then
remove the cover.
2
1. Top cover
2. Main switch coupler
64
To install the top cover
1.
Connect the main switch coupler.
2.
Place the top cover in the original posi-
tion, making sure to fit the projections on
2
the cover into the slots in the headlight
unit.
1. Top cover
3.
Tighten the quick fastener screws.
4.
Pass the brake hose, throttle cable, park-
ing brake cable and wire harness through
the cable guide, place the cable guide in
the original position, and then install the
screws.
1
1. Cable guide
5.
Connect the auxiliary DC jack coupler.
6.
Install the left side cover and the shroud.
ECS00372
NOTICE
Make sure that all cables, hoses and
●
leads are routed properly before install-
ing the shroud and covers.
1
1
Advertisement
Table of Contents
