Yamaha RS VECTOR Owner's Manual page 105

1. Rear axle nut
2. Lift the rear of the snowmobile onto a suit-
able stand to raise the drive track off the
ground.
3. Start the engine and rotate the drive track
one or two turns. Stop the engine.
4. Loosen the locknut on the left and the
right sides of the snowmobile, then align
the drive track by turning the adjusting
bolt on each side.
Drive track Shifted to
alignment
Left adjusting
Turn out
bolt
Right adjust-
ing bolt
1 3
1. Left adjusting bolt
2. Right adjusting bolt
3. Locknut
Periodic maintenance and adjustment
Shifted to left
right
Turn in
Turn in Turn out
3
Shifted to right
1
1. Forward
2. Gap
3. Slide runner
4. Drive track
5. Slide metal
Shifted to left
1. Forward
2. Gap
3. Slide runner
4. Drive track
5. Slide metal
5. Adjust the drive track deflection to speci-
fication. NOTICE: The right and left ad-
justing bolts should be turned an
2 equal amount.
Drive track
deflection
Left adjusting
bolt
Right adjust-
ing bolt
[ECS00970]
More than Less than
specified specified
Turn in Turn out
Turn in Turn out
99