Table of Contents
Advertisement
Control functions
1. Compression damping force adjusting knob
Compression damping force setting:
Minimum (soft):
12 click(s) in direction (b)*
Standard:
6 click(s) in direction (b)*
Maximum (hard):
2 click(s) in direction (b)*
* With the adjusting knob fully turned in
direction (a)
RS90P / RS90PLT
The rebound damping force can be adjusted
by turning the adjusting knob.
To increase the rebound damping force, turn
the adjusting knob in direction (a). To de-
crease the rebound damping force, turn the
adjusting knob in direction (b). NOTICE: Do
not continue to turn the adjusting knob in
direction (a) after it stops. The shock ab-
sorber could be damaged and damping
force adjustments will not be able to be
made. Do not turn the adjusting knob in di-
rection (b) more than 20 click(s). Even if
the adjusting knob is continually turned
after 20 click(s), there will be no change in
the damping force. Be sure to stop the ad-
justing knob at a position where there is a
click.
[ECS01060]
42
(a)
(b)
1
1. Rebound damping force adjusting knob
Rebound damping force setting:
Minimum (soft):
20 click(s) in direction (b)*
Standard:
11 click(s) in direction (b)*
Maximum (hard):
3 click(s) in direction (b)*
* With the adjusting knob fully turned in
direction (a)
ESU11047
Adjusting the control rods
The weight transfer can be adjusted by turn-
ing the adjuster on the control rod (RS90P /
RS90PLT) or the adjusting nuts on the control
rods (RST90 / RST90PGT).
RS90P / RS90PLT
1.
Check the control rod length using the
scale on the special wrench as shown.
TIP
In order to obtain a precise measurement, the
special wrench corner should touch the con-
trol rod adjuster, and the locknut must be
turned so that one of its notches aligns with
the wrench allowing the wrench to fit horizon-
tally on the control rod.
(b)
(a)
1
Advertisement
Table of Contents
