25.3. DURING RESTART
During the "restart", no fire alarm can be activated and the following is shown in the display:
And after a few seconds (if not, see section
Booting...
A fault will be generated and the following text message will be shown in the display and the buzzer will sound:
FAULT: Restart control unit nn, code xx,
address yyyyyy
Regarding code xx and address yyyyyy, see section
ing equipment "Fault tx activated" and Fault / Disablements "General fault".
After the fault is acknowledged (via menu H6), the LEDs will be turned OFF if there are no other faults.
After any restart, required individual disablements have to be done.
on page 85):
25.3.1. MEMORY FAULT
25.2. RESTART TABLE
84
on page 83. This fault is also indicated by LEDs Rout-