BMW 7 Series Owner's Manual page 377

2. This device must accept any interference, in-
cluding interference that may cause undesired
operation of the device.
L'exploitation est autorisée aux deux condi-
tions suivantes:
1. L'appareil ne doit pas produire de brouillage.
2. L'appareil doit accepter tout brouillage radi-
oélectrique subi, même si le brouillage est sus-
ceptible d'en compromettre le fonctionnement.
USA/Canada
HeadUnit (Garmin)
Model: MGU22
FCC ID: IPH-03910
IC: 1792A-03910
Changes or modifications not expressly ap-
proved by the party responsible for compliance
could void the user's authority to operate the
equipment.
This device complies with part 15 of the FCC
Rules and contains licence-exempt transmit-
ter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada's
licence-exempt RSS(s). Operation is subject to
the following two conditions:
1. This device may not cause harmful interfer-
ence.
2. This device must accept any interference re-
ceived, including interference that may cause
undesired operation.
This radio transmitter has been approved by
the FCC/ISED to operate with the antenna
types listed below with the maximum permissi-
ble gain indicated. Antenna types not included
in this list, having a gain greater than the max-
imum gain indicated for that type, are strictly
prohibited for use with this device.
Interface and frequency range: Bluetooth &
Wifi @ 2.4GHz
Type: ¼ wave coax
Max Gain: -2.5 dBi
Online Edition for Part no. 01405A5EA63 - VI/22
Appendix
Interface and frequency range: Wifi @ 5GHz
Type: ¼ wave coax
Max Gain: -2.8 dBi
This device complies with the FCC/ ISED RF
exposure limits and has been evaluated in
compliance with portable exposure condition.
The exposure standard for wireless mobile
phones/portable devices employs a unit of
measurement known as the Specific Absorp-
tion Rate, or SAR. This device has been shown
to be capable of compliance for localized SAR
for uncontrolled environment/general popula-
tion exposure limits specified in ANSI/IEEE
Std. C95.1-1992 and has been tested in ac-
cordance with the measurement procedures
specified in ISED RSS-102 and IEEE Std. 1528-
2013. The standards include a substantial
safety margin designed to assure the safety of
all persons, regardless of age and health. The
standard incorporates a substantial margin of
safety to give additional protection for the pub-
lic and to account for any variations. To comply
with the measured SAR value/SAR testing ex-
clusion, the equipment must be installed and
operated with a minimum distance of 51 mm of
the human body.
FCC Class B device notice Note: This equip-
ment has been tested and found to comply
with the limits for a Class B digital device, pur-
suant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential in-
stallation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the in-
structions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or televi-
sion reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
REFERENCE
377