BMW 7 Series Owner's Manual page 286

CONTROLS
Press and hold the desired button of the re-
mote-controlled system within range until the
function is triggered.
The LED on the interior mirror is continuously
illuminated green during the transmission of
the radio signal.
Deleting a button assignment
The button assignment cannot be deleted indi-
vidually.
Press and hold the two outer buttons on
the interior mirror simultaneously for approxi-
mately 10 seconds until the LED flashes green
rapidly.
All stored button assignments will be deleted.
Sun visor
Glare shield
Fold the sun visor down or up.
Glare shield from the side
Folding the sun visor out
1. Fold the sun visor down.
2. Detach it from the holder and swing it to-
ward the side window.
3. Shift it back to the desired position.
Folding the sun visor in
Proceed in the reverse order to close the sun
visor.
Vanity mirror
A vanity mirror is located in the sun visor be-
hind a cover.
286
Interior equipment
Online Edition for Part no. 01405A5EA63 - VI/22
Sockets
Principle
The socket can be used for electronic devi-
ces when the standby or drive-ready state is
switched on.
General information
The total load of all sockets must not exceed
140 watts at 12 volts.
Do not damage the socket by using unsuitable
connectors.
Safety information
Warning
Devices and cables in the unfolding area of
the airbags, such as portable navigation de-
vices, can hinder the unfolding of the airbag
or be thrown around in the car's interior dur-
ing unfolding. There is a risk of injury. Make
sure that devices and cables are not in the
airbag's area of unfolding.
NOTICE
Battery chargers that charge the vehicle bat-
tery via sockets or cigarette lighters in the
vehicle may overload or damage the 12 V
electrical system. There is a risk of damage
to property, among other potential damage.
Only connect battery chargers for the vehicle
battery to the jump-start terminals in the en-
gine compartment.